rust removable by electrolysis

Seadog · Post by **Seadog** » Mon Nov 16, 2015 5:51 pm

Sounds good.

mike in idaho · Post by **mike in idaho** » Sun Nov 22, 2015 12:05 pm

This is what I pulled out of a Goldwing tank via electrolysis:http://www.honda305.com/upload/h305_for ... 88_686.jpg
The interior of the tank looked like new afterwards.
goldwing parts 005

Seadog · Post by **Seadog** » Sun Nov 22, 2015 12:15 pm

What a great job, Mike! Look at the crud on that electrode....

seabat · Post by **seabat** » Sun Nov 22, 2015 12:52 pm

WOW my 305 tank came out good but no way shiny like yours, great job

seabat

mike in idaho · Post by **mike in idaho** » Sun Nov 22, 2015 3:47 pm

It took several days, pulled the electrode out and cleaned it several times. The hard part was fooling my "smart" battery charger into putting out some amps. I piggy-backed a run-down car battery on, in parallel, to get it to go.

Seadog · Post by **Seadog** » Sun Nov 22, 2015 7:09 pm

What did you rig up to hold the electrode, Mike?

mike in idaho · Post by **mike in idaho** » Sun Nov 22, 2015 9:36 pm

I used a piece of plastic from the side of an antifreeze jug with a hole in the center to hold the re-bar. After doing the main part of the tank, I tipped it up to get the filler neck wet (it's higher than the sender unit) and moved the electrode there for another day.

honda305.com Forum

honda305.com Forum

rust removable by electrolysis