Welded Shifter

Hahnda · Post by **Hahnda** » Wed Sep 19, 2012 10:54 am

There is a master link but the odds of it being in the spot you need it to be in are pretty slim.

You could dump some sort of penetrant into the spark plug holes and be patient. Maybe it will free up.

MRiesAP · Post by **MRiesAP** » Wed Sep 19, 2012 11:00 am

Tried that already. Was working on tearing rest of engine down when hit the shift problem. thinking of grinding down the weld and trying that route. Will look for master link and pray.

mobilyte · Post by **mobilyte** » Wed Sep 19, 2012 2:31 pm

remove the cams and you'll have enough slack to slip the cam chain off the sprocket.

Hahnda · Post by **Hahnda** » Wed Sep 19, 2012 3:07 pm

mobilyte wrote:remove the cams and you'll have enough slack to slip the cam chain off the sprocket.

Good advice! I think I may have even done that once or twice. Kinda forgot about that.

MRiesAP · Post by **MRiesAP** » Thu Sep 20, 2012 5:44 am

I will give it a go this weekend.

Mike Mullins · Post by **Mike Mullins** » Thu Sep 20, 2012 6:37 am

You've probably already looked for the master llink in these spots, but just in case, take a look inside where the chain tensioner and oil pump openings are and make sure you cant access the master link through these. I've been lucky once or twice with this.
Mikeyrx

MRiesAP · Post by **MRiesAP** » Thu Sep 20, 2012 9:07 am

The only one I have not checked is the oil pump. Good thinking.

honda305.com Forum

honda305.com Forum

Welded Shifter