valve guide Remmoval

thepunisher2007 · Post by **thepunisher2007** » Tue Feb 19, 2019 7:58 am

ill try the oven trick then next. is there any need to have the head skimmed after or is there no chance of warping in from the heat?

AlanW · Post by **AlanW** » Tue Feb 19, 2019 8:09 am

Never had distortion problems but it always pays to check the flatness.
Al.

thepunisher2007 · Post by **thepunisher2007** » Wed Feb 20, 2019 4:27 am

so cooking time wise how long is it best to leave it baking for.

DJM · Post by **DJM** » Wed Feb 20, 2019 5:09 am

Provided that your wife's oven thermostat is working you can't overcook it, it will only get up to the temperature of the oven regardless of how long you leave it in there.

A cylinder head is a BIG lump of metal which will take a long while to heat right through.

I would say a minimum of 2 - 3 hours maybe longer and DON'T Forget some GOOD oven gloves, it would be a shame to drop it!

AlanW · Post by **AlanW** » Wed Feb 20, 2019 4:32 pm

Never left one more than 1/2 an hour once the oven is up to temp and it has always worked,
as Dennis says use good gloves you really don't want to drop it, that's why I use welding ones.
Al.

thepunisher2007 · Post by **thepunisher2007** » Sat Feb 23, 2019 7:15 am

ok so it’s in the oven now i’ll left you know how i get on

thepunisher2007 · Post by **thepunisher2007** » Sat Feb 23, 2019 7:21 am

thank you so much for all your help i’m happy to report the guides are out. would you recommend heating the new ones in

Honda305.com Forum

honda305.com Forum

valve guide Remmoval

Cooking time

valve guides