Front mudguard/fender

G-Man · Post by **G-Man** » Fri Sep 04, 2015 7:55 pm

Malcolm

Thanks! That sounds good.

Graham

malcolmgb wrote:
G-Man wrote:
I would love to get an alloy one made for my '61 bike.

Graham I recently met someone local who may be able to help you, will speak when you get back.

modelman · Post by **modelman** » Mon Sep 07, 2015 6:53 am

R100 wrote:modelman - that is beautiful.
How did you make that? Mold? Heat? English wheel?

When its finished & IF it turns out OK, then I'll reveal all !

G-Man · Post by **G-Man** » Mon Sep 07, 2015 7:00 am

I'm on the edge of my seat...... :-)

G

modelman · Post by **modelman** » Wed Sep 09, 2015 10:49 am

Well what can I say, I was just about to start some tin-bashing when I received a PM from one of our members offering me a set of mudguard/fender stays, these would have been a big challenge for me to make them & I anticipated several attempts!!
Of course I accepted, but our friend would NOT accept any reimbursement, you know who you are, so THANK YOU very much once again.

So, realising my 'first-fit' was a bit out, I spent the day fettling/tweaking the fit, & ended up with something similar to all the pics on the web.
Feel free to tell me if its still 'off' & i'll try harder!!

Next jobs will be the chain guard, once I've sorted some card for templates, & then that little 'tail' at the rear, I might have a go at rubber-casting that.

G-Man · Post by **G-Man** » Wed Sep 09, 2015 11:24 am

Super work!!

G

PhilD · Post by **PhilD** » Wed Sep 09, 2015 11:41 am

Front mud guard looks spot on. Bike looks beautiful. Where did you get the mirrors from? They look big enough that even I could see around my elbows in them.
PhilD

SMBH · Post by **SMBH** » Wed Sep 09, 2015 2:43 pm

Nice one modelman.

Honda305.com Forum

honda305.com Forum

Front mudguard/fender