CB72 Swinging Arm Nut Torque ?

[Phil-UK]

I've slackened off the swinging arm to clean up the footrest plates and wondered if anyone has a torque figure for tightening the self locking nut ?

When I assembled it I did it so the swinging arm would just drop under its own weight but as everything else is in place it would be easier if I could just torque it up.

Thanks in advance,

Phil

[LOUD MOUSE]

I don't know I've seen a number fore this.
I do as you did after I've pulled down tight on the nut to position all parts then slack back to allow the arm to move without much force. .....lm

I've slackened off the swinging arm to clean up the footrest plates and wondered if anyone has a torque figure for tightening the self locking nut ?

When I assembled it I did it so the swinging arm would just drop under its own weight but as everything else is in place it would be easier if I could just torque it up.

Thanks in advance,

Phil