Opening Right Side Casing

paperslammer · Post by **paperslammer** » Mon Jul 15, 2013 3:14 pm

Thanks Oldstan - I have something that works now.

Is there anything else I should do while I'm inside the casing? Anything else I should check on?

Oh and there should be two ball bearings between the end of the gearshaft / gear axel and the right side casing, correct? I found two in there. (I think it was the gearshaft).

Thanks

mschehen · Post by **mschehen** » Sat Jul 20, 2013 10:01 am

Actually I think you are looking at the clutch pushrod and on my bikes I am pretty sure there is only one bearing between the rod and the case. There is also a bearing on the kickstart mechanism.

mike in idaho · Post by **mike in idaho** » Sat Jul 20, 2013 12:01 pm

Something like this works fine: http://www.mfgsupply.com/32-5801.html?s ... QgodTG0A3w
You find them any place where chain saws and garden tools are sold.

paperslammer · Post by **paperslammer** » Mon Jul 22, 2013 11:43 pm

Thanks everyone! I'm going to work on this on Saturday and I'll put up some pictures and a how-to on replacing the clutch cable and taking the side panel off.

Honda305.com Forum

honda305.com Forum

Opening Right Side Casing

What next

Thanks!