Fuel System: Gas (Petrol) tanks, Carburators
-
Jlovvorn
- honda305.com Member
- Posts: 477
- Joined: Tue Dec 27, 2011 11:10 am
- Location: Washington DC
Post
by Jlovvorn » Fri Mar 09, 2012 7:07 pm
Left carb - long cutout point inward, short cutout faced out.
Right carb - long cutout inward, short cutout out
-
LOUD MOUSE
- honda305.com Member
- Posts: 7818
- Joined: Mon Aug 15, 2005 8:23 am
- Location: KERRVILLE, TEXAS
Post
by LOUD MOUSE » Fri Mar 09, 2012 8:11 pm
Each slide will have a angled area at the bottom.
That will always face the open end of the carb not toward the engine. .........................lm
Jlovvorn wrote:Left carb - long cutout point inward, short cutout faced out.
Right carb - long cutout inward, short cutout out
-
Jlovvorn
- honda305.com Member
- Posts: 477
- Joined: Tue Dec 27, 2011 11:10 am
- Location: Washington DC
Post
by Jlovvorn » Fri Mar 09, 2012 8:26 pm
Thanks. Got them in right now. One was backwards. Does this list have Darwin Awards?
-
rzgkane
- honda305.com Member
- Posts: 537
- Joined: Sun Feb 12, 2012 11:12 pm
- Location: Huntington Beach, CA
Post
by rzgkane » Fri Mar 09, 2012 9:11 pm
Jlovvorn wrote:Thanks. Got them in right now. One was backwards. Does this list have Darwin Awards?
Hey man. Anyone who is good at anything effed it up many times before they got there.
I do recommend, though, that you make use of a digital camera for your posts. Everything is clearer in pictures.
-
LOUD MOUSE
- honda305.com Member
- Posts: 7818
- Joined: Mon Aug 15, 2005 8:23 am
- Location: KERRVILLE, TEXAS
Post
by LOUD MOUSE » Fri Mar 09, 2012 9:52 pm
One was in backwards. ?????????
If ya were able to turn it 180 and it slides in it means the KEY in the carb which keeps the slide in position is gone. .????????????. lm
Jlovvorn wrote:Thanks. Got them in right now. One was backwards. Does this list have Darwin Awards?
-
Jlovvorn
- honda305.com Member
- Posts: 477
- Joined: Tue Dec 27, 2011 11:10 am
- Location: Washington DC
Post
by Jlovvorn » Fri Mar 09, 2012 10:38 pm
The key is there, but I had it in with the short cut out inwards and the long one out.
It kept the slide from bottoming out. It went in fat enough to put the cap on.
Stopped about 3/4 of the way in.
Turned it around and all is well.
-
LOUD MOUSE
- honda305.com Member
- Posts: 7818
- Joined: Mon Aug 15, 2005 8:23 am
- Location: KERRVILLE, TEXAS
Post
by LOUD MOUSE » Sat Mar 10, 2012 3:57 am
Got it. .............lm
Jlovvorn wrote:The key is there, but I had it in with the short cut out inwards and the long one out.
It kept the slide from bottoming out. It went in fat enough to put the cap on.
Stopped about 3/4 of the way in.
Turned it around and all is well.
