Trick with pulling the rotor off?

hillhudson · Post by **hillhudson** » Thu Nov 24, 2011 3:56 pm

i found this bolt right away at my local hardware store, works great. 50 cents later. i thread it in than use an electirc impact screw driver to screw it in and pull the rotor off. easy as cake. takes a total of 2 seconds,

good luck

GarageRacer · Post by **GarageRacer** » Thu Nov 24, 2011 4:37 pm

I got the rotor off yesterday after going to Tacoma Screws. Found a surprise where I'm missing some little part from the rotor, three spring thingies and one of the sets are missing a part. Gotta source it.

It's really funny. This started off as a simple engine seal replacement and right now I have half the bike apart with parts all over the place.

48lesco · Post by **48lesco** » Thu Nov 24, 2011 11:20 pm

Hey - Happy Thanksgiving! And before you pay a lot on ebay, try an online or local Honda dealer for those starter clutch parts, they may all still be available.

Jethro · Post by **Jethro** » Thu Nov 24, 2011 11:37 pm

Yeah I know the springs are still available. I have some extra rollers if you need.

Jethro

GarageRacer · Post by **GarageRacer** » Sat Nov 26, 2011 3:08 am

Thanks. I ended up ordering a used rotor of ebay so I have all the parts I need.

Honda305.com Forum

honda305.com Forum

Trick with pulling the rotor off?