5mm .90 screws

[56_oval]

I know this may sound weird, but I took the 5x0.8 screws I got at a shop and shoved em through a 5x0.9 Die. I wouldn't trust em at 20+ lbs of torque, but I've had no problems with em holding the stator cover on and we all know how much vibration we get out of this little engine.

[Dana01]

Re. starter cover:

Not caring about being "correct" and wanting matching stainless allen-heads, I found my 6mm tap very useful. Just had to drill out the starter cover holes a bit. Plenty of meat.

Haven't got to the timing cover yet, but plans are the same.