adjusting cam chain problems !

tavarama · Post by **tavarama** » Mon Apr 11, 2011 12:24 am

it says to loosen the bolt on the engine and re tighten and an automatic plunger system will pick up the slack, but when i electric start my superhawk i can here the cam chain smacking around when its trying to fire up. it sounds awful. how can i get this chain slackless !!!!!!

http://a2.sphotos.ak.fbcdn.net/hphotos- ... 4717_n.jpg

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Apr 11, 2011 12:29 am

Ya sure it isn't the starter chain?. ...........lm

tavarama wrote:it says to loosen the bolt on the engine and re tighten and an automatic plunger system will pick up the slack, but when i electric start my superhawk i can here the cam chain smacking around when its trying to fire up. it sounds awful. how can i get this chain slackless !!!!!!

http://a2.sphotos.ak.fbcdn.net/hphotos- ... 4717_n.jpg

tavarama · Post by **tavarama** » Mon Apr 11, 2011 1:22 am

Ah yes thats what I meant. How can I adjust the slack if possible? I watched it as I was starting my bike and it was jumping all over and sounded like pennies in a blender. It only happens every so often

tavarama · Post by **tavarama** » Mon Apr 11, 2011 2:05 am

Ah yes thats what I meant. How can I adjust the slack if possible? I watched it as I was starting my bike and it was jumping all over and sounded like pennies in a blender. It only happens every so often

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Apr 11, 2011 7:08 am

They are all the same length when new and are rather loose also.
Ya could install washers between the starter and the 4 bolts. .......lm

tavarama wrote:Ah yes thats what I meant. How can I adjust the slack if possible? I watched it as I was starting my bike and it was jumping all over and sounded like pennies in a blender. It only happens every so often

davomoto · Post by **davomoto** » Mon Apr 11, 2011 10:30 am

LOUD MOUSE wrote:They are all the same length when new and are rather loose also.
Ya could install washers between the starter and the 4 bolts. .......lm

I tried doing that one time, and then the aluminum starter cover won't go back on as it messes up the alignment of the screw holes.

Davo

tavarama · Post by **tavarama** » Mon Apr 11, 2011 5:19 pm

okay LM. im back again about the smoke. my right side is def. not firing despite new splugs and i striped the wire doen and screwed the plug boot onto less worn wire. everything is set the the right adjustments. the smoke is coming from my engine internally from what i can see. it smokes immediately if it is warmed. is this a blown ring? i took my muffler off and noticed oil seeping out around end of muffler. how much does this cost to replace? i was contemplating an entire engine rebuild cause i doubt this engines gaskets have ever been replaced. yet is has less than 6000 miles on it. what would be the smartest direction to go?

Honda305.com Forum

honda305.com Forum

adjusting cam chain problems !

adjusting cam chain problems !

Re: adjusting cam chain problems !