original finishing of the cylinder and cylinder head

jensen · Post by **jensen** » Fri Dec 18, 2009 8:39 am

Hi chico,

If beat blasting a used cylinder head, it's only is more time consuming, but the results will be comparable,

jensen

rbaselt · Post by **rbaselt** » Fri Dec 18, 2009 8:40 am

After bead-blasting a used head/cylinder, if you spray lightly with a high-temp flat silver or dull aluminum paint, it looks very close to original. And after running (or baking in an oven) for an hour, the paint is very durable and provides an easy-to-clean surface. --Randall

jensen · Post by **jensen** » Fri Dec 18, 2009 8:46 am

Hi,

Yes, I think it will be the same color, can you show us pictures to compare ?
The picture of the nos head (non-blasted) is to compare. Are you sure to use dull aluminum ?
As you can see on the pictures, the surface isn't dull, but shiny (not glossy).

Jensen

rbaselt · Post by **rbaselt** » Fri Dec 18, 2009 10:12 am

I don't have any photos, unfortunately. But I have used this treatment on about 6 bikes that I restored, and it works very well. You don't want to use a bright silver or aluminum soray, since these are glossy and look "painted". The dull or flat sprays have a metal-like sheen when cured.
Randall

Hondac71 · Post by **Hondac71** » Fri Dec 18, 2009 10:33 am

The way i had my parts done is by vapour blasting, gets the parts shining like new and no paint required!

jensen · Post by **jensen** » Fri Dec 18, 2009 11:50 am

hoi jelle,

Wat is dat ?, hoe werkt dat ?
Heb je er ook foto's van ?

jensen

(hi jelle,

waht is it, how soes it work ?
so you have any pictures ?

Jensen)

honda305.com Forum

honda305.com Forum

original finishing of the cylinder and cylinder head

blasting