Starter Motor - replacement Manufacturer's Plate

Phil-UK · Post by **Phil-UK** » Mon Mar 16, 2009 8:33 am

Hi All

Anyone any experience of repalcing the maker's ID plate on the CB72/77 starter motors ?
All of mine have damaged plates and I was wondering if anyone has ever had vinyl ones made
up ( or photo-etched ) to stick over the originals ?
With all the fancy stuff possible with modern computer graphics I'm assuming its possible.

thanks

Phil

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Mar 16, 2009 9:33 am

Are ya aware that HONDA didn't put that tab on all the starter motors for the C/CA/CB72/77's. ...........lm

Phil-UK wrote:Hi All

Anyone any experience of repalcing the maker's ID plate on the CB72/77 starter motors ?
All of mine have damaged plates and I was wondering if anyone has ever had vinyl ones made
up ( or photo-etched ) to stick over the originals ?
With all the fancy stuff possible with modern computer graphics I'm assuming its possible.

thanks

Phil

Phil-UK · Post by **Phil-UK** » Mon Mar 16, 2009 9:48 am

Thanks Loud Mouse,,

Nope, wasn't aware that it wasn't present on all of them, but all of mine have the plate but
they are all damaged - either the facing has worn off or the actual plate has bits missing.
perhaps it would be easier to just remove it ...

cheers

Phil

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Mar 16, 2009 10:23 am

I'd say tis easier to remove and then fill the holes then paint. ........lm

Phil-UK wrote:Thanks Loud Mouse,,

Nope, wasn't aware that it wasn't present on all of them, but all of mine have the plate but
they are all damaged - either the facing has worn off or the actual plate has bits missing.
perhaps it would be easier to just remove it ...

cheers

Phil

Phil-UK · Post by **Phil-UK** » Fri Mar 27, 2009 4:31 am

Thank LM .. will go down that route ... Phil

honda305.com Forum

honda305.com Forum

Starter Motor - replacement Manufacturer's Plate

Starter Motor - replacement Manufacturer's Plate

Re: Starter Motor - replacement Manufacturer's Plate