Rear Wheel Bearings

68Cb77 · Post by **68Cb77** » Thu Mar 20, 2008 6:21 pm

I've got 2 new bearings ready to go in the hub. One side is sealed, and the other side has the balls more exposed. When I took the old ones out, the sealed side was on the outside. Is that right? Thanks

ggray · Post by **ggray** » Thu Mar 20, 2008 6:48 pm

Seals go to the outside.

Gary

68Cb77 · Post by **68Cb77** » Thu Mar 20, 2008 8:02 pm

Thanks Gary

ggray · Post by **ggray** » Fri Mar 21, 2008 8:48 am

You're welcome. Just make sure you pack the bearings well and grease goes in the void between the inner and outer bearing..........Where the bearing spacer is.

Gary

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Mar 21, 2008 11:11 am

Grease in the void/spacer???????????. .........lm

ggray wrote:You're welcome. Just make sure you pack the bearings well and grease goes in the void between the inner and outer bearing..........Where the bearing spacer is.

Gary

68Cb77 · Post by **68Cb77** » Sat Mar 22, 2008 10:18 am

Don't need to fill that with grease?

LOUD MOUSE · Post by **LOUD MOUSE** » Sat Mar 22, 2008 4:41 pm

Not even. The axle goes through it but doesn't touch it. ...............lm

68Cb77 wrote:Don't need to fill that with grease?

Honda305.com Forum

honda305.com Forum

Rear Wheel Bearings

Rear Wheel Bearings

seals

Seals

Re: Seals