CL72 Project

malcolmgb · Post by **malcolmgb** » Sun Jun 09, 2013 3:34 pm

I recently bought this, it looks like it may turn into a retirement project, just over 18 months to my 65th Birthday.

Some things I am going to need are;
Seat
Right side panel
Ignition switch
Coils
Passenger footrests
If anyone has any of these parts please contact me.

G-Man · Post by **G-Man** » Mon Jun 10, 2013 1:51 am

Malcolm

I can probably help with most of those. I'll look through my pile of parts over the next few days.

Nice looking tank on that project!

G

malcolmgb · Post by **malcolmgb** » Mon Jun 10, 2013 11:07 am

Thanks G, yes the tank looks good but I think the tap fittings have been altered. I forgot to include it is also missing handlebars.

G-Man · Post by **G-Man** » Mon Jun 10, 2013 11:58 am

What about the mudguards / fenders? They should be alloy on early CL72s.

G

malcolmgb · Post by **malcolmgb** » Mon Jun 10, 2013 3:17 pm

Yes have alloy guards, I forgot to put them in picture.
The front is very dented I am hoping it can be straightened by a good sheet metal worker, the rear is good but will need some welding around the license plate fixing area. The front guard bracket needs some welding and straightening too, then re-chrome.

G-Man · Post by **G-Man** » Mon Jun 10, 2013 4:33 pm

You're going to be busy!

G

malcolmgb · Post by **malcolmgb** » Mon Jun 10, 2013 4:44 pm

Yes & very poor too I think. How rare are fuel tank knee pads? I have seen replicas but very expensive, I am not planning a concors rebuild just a very tidy daily rider so old parts will be used.

honda305.com Forum

honda305.com Forum

CL72 Project

CL72 Project