where to get machine work done on head?

hoodooman · Post by **hoodooman** » Sun Mar 27, 2011 9:33 pm

hi guys,
i picked up a second 305 engine. it needs a complete valve job. i asked my local napa machine shop if they can do the work, and they said they can't because it's too small. Where can i get the seats cuts and new valve guides installed? also, where can i get new oversized valves and springs that are genuine honda?

Thanks for the help in advance

Dana01 · Post by **Dana01** » Sun Mar 27, 2011 11:58 pm

These guys can do the work:

http://www.qande.com

Please note: I can't vouch for anything .. they just said they can do a valve job on my CB-550. They quoted $245 on up for the above motor valve job and port cleanup. No idea on a 305 rate.

Ask for Vance Qualls

davomoto · Post by **davomoto** » Mon Mar 28, 2011 8:59 am

Hoodoman, where are you located? I take mine to Best Machine in San Rafael Ca. Last one I took him was $125, valves and seats cut, mating surface machined.

Davo

hoodooman · Post by **hoodooman** » Thu Mar 31, 2011 7:25 pm

i'm in ohio, noone around here that i can't find to do the work! if i could just find some new valves, i think that would be good enough. the seats may not need cut, just cleaned.

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Mar 31, 2011 7:47 pm

Ya are new to this forum and we don't know where are actually located so how in this world would this forum be able to offer a location of help with what ya will ever want help with?
BTW new valves will not fix any problem until the valve seats in the head have been cut to the matching contact surface of the valve when installed.
Head/valve contacts must be matched!!!!!!!!!!!.
SIMPLE like WHAT!!!!!. ....LM

hoodooman wrote:i'm in ohio, noone around here that i can't find to do the work! if i could just find some new valves, i think that would be good enough. the seats may not need cut, just cleaned.

MINIGUNZ · Post by **MINIGUNZ** » Fri Apr 01, 2011 10:48 pm

I just had VANCE QUALLS at Q&E DO MY 305 head seats, i had new valves already. and I had glass beaded the head of all carbon and grime at my shop first, the cost was $40.00 TO CUT THE NEW SEATS to match the valves i supplied. Well worth the money. ANAHIEM , CALIFORNIA

Vince Lupo · Post by **Vince Lupo** » Sat Apr 02, 2011 6:05 am

Another source here in Maryland -- been doing it for 41 years: http://www.laddporting.com

Honda305.com Forum

honda305.com Forum

where to get machine work done on head?

where to get machine work done on head?

Q&E ENGINEERING HEAD WORK