Need Magneto Puller

Boxler 65 Dream 305 · Post by **Boxler 65 Dream 305** » Thu May 07, 2015 11:33 am

Does anyone know where I can get a magneto puller with these dimensions? puller must have a male thread of 36mm x 1.5 thread pitch.
I need it to pull a Kokusan Denki magneto on a 1955 Dream SA

OldScrambler · Post by **OldScrambler** » Wed May 13, 2015 8:40 am

I don't know your exact application.............but on some models the rear axle thread is the same. By use of a bar-bell weight (or some other type of heavy donnut) you can make a slide-hammer and pull the rotor.

LOUD MOUSE · Post by **LOUD MOUSE** » Wed May 13, 2015 11:09 am

I went to my ACE Hardware store and they had them in the Metric Bolt Tray.
True Value may have them. .............lm

Boxler 65 Dream 305 wrote:Does anyone know where I can get a magneto puller with these dimensions? puller must have a male thread of 36mm x 1.5 thread pitch.
I need it to pull a Kokusan Denki magneto on a 1955 Dream SA

Boxler 65 Dream 305 · Post by **Boxler 65 Dream 305** » Thu May 14, 2015 7:46 am

I did locate a puller, just located one yesterday. This is a rare thread on this bolt size. I had to have someone machine the threads. The bolt diameter was 36mm (approx 1.400" diameter) with a 1.5mm thread pitch. The length was not to critical so I did not specify length. Anyways I am all set now but thanks for the responses. I am restoring a 1955 Honda Dream SA.

Honda305.com Forum

honda305.com Forum

Need Magneto Puller

Need Magneto Puller

Re: Need Magneto Puller

magneto puller