separating an engine case with honda bond

[rickytile]

i am having difficulty separating an engine case with honda bond. does anyone have an easy method or tool to assist. I dont want to use a rudimentary hammer and flathead to casue permanent damage. thank you!

[jsmith1107]

LM told me this one and it worked for me so here you go. There are two bolts sticking out the top of the engine where the painted engine guard goes correct? Take a 2x4 or a piece of hard lumber and a hammer---put the lumber on the bolts and smack it hard with the hammer a few times. It will maybe take a few good smacks but it will come loose. I did this and it took about 10 good whacks and it finally came loose.

Hope that helps.

[Hoosier Tom]

Don't forget about the two top studs with the 8mm nuts. Loosen those and set the nuts flush to protect the stud threads, and after making sure all bottom nuts and bolts are out, whack the protected studs to loosen the cases. Put a small block of wood over the studs/nuts and hit it.

HT

[rickytile]

thank you gentlemen. the problem now is that the side cover has honda bond on it too and i cant pry it off. any suggestins on that front?

[Jethro]

Just some patience, a razor blade, maybe a soft blow hammer and some finesse.