Page 164 of 167

CL fuel taps

Posted: Sat Feb 02, 2019 12:07 pm
by DJM
Interesting, when I restored my CL77 a while ago I ordered a load of new bits too. The O ring that came to go between the tap and the tank was actually a rectangular section rather than round and was pre-shaped to fit the groove in the tap. When I ordered a second one as a spare it was a normal round section O ring but both came in sealed packets bearing the same part number, just another example of a superseded component without a part number change I suppose

BTW, were there any red fibre washers on the screws holding the CL taps onto the fuel tanks?

Re: CL fuel taps

Posted: Sat Feb 02, 2019 12:47 pm
by G-Man
DJM

Yes - I need to get a load of red fibre washers and some new screws for mounting the taps.

Unusual for Honda to use a 'standard size' for that 'oval' o-ring. In my CL77 manual it says that the -273- part is superceded but the single one I got from DSS had a -273- number

I wish they'd done something similar with the wavy washer under the tap lever. You could buy 50 of the nearest size (which doesn't fit) for the price of one Honda one.

G


DJM wrote:Interesting, when I restored my CL77 a while ago I ordered a load of new bits too. The O ring that came to go between the tap and the tank was actually a rectangular section rather than round and was pre-shaped to fit the groove in the tap. When I ordered a second one as a spare it was a normal round section O ring but both came in sealed packets bearing the same part number, just another example of a superseded component without a part number change I suppose

BTW, were there any red fibre washers on the screws holding the CL taps onto the fuel tanks?

Posted: Mon Feb 18, 2019 5:12 pm
by G-Man
I finally got around to firing up the 'big bore' Gilera engine after getting it on the test stand. It needed a little tweaking of the ignition timing and priming the oil pump which appeared to be air-locked.

Back to the Hondas now. I've run out of excuses....

Click on the picture below to hear it run.....

Image

G

Posted: Mon Feb 18, 2019 8:11 pm
by oldbikedude
Nice toy G man.

Posted: Tue Feb 19, 2019 2:59 am
by G-Man
No mine - belongs to a friend.... :-)

G

oldbikedude wrote:Nice toy G man.

Posted: Tue Feb 19, 2019 4:01 am
by AlanW
Good fun isn't it G, especially when it fires after all that time. Very satisfying.

Posted: Tue Feb 19, 2019 12:15 pm
by G-Man
Alan

Certainly is! :-)

G

AlanW wrote:Good fun isn't it G, especially when it fires after all that time. Very satisfying.