Ordering parts for a Type 2 engine

cbxmountainman · Post by **cbxmountainman** » Wed Jul 23, 2008 10:53 am

Ooops!! My factory service manual just showed the points on the RIGHT side. Sorry about that. Forgot I had the thing, but looked when I found it.

cbxmountainman · Post by **cbxmountainman** » Wed Jul 23, 2008 10:55 am

Sorry about the multiple postings. Finger got carried away.

CliffC · Post by **CliffC** » Wed Jul 23, 2008 12:26 pm

CBX, Ahh, you just wanted all that print. Just joking, that is good info on the Type 2's, I had to dig into the memory bank from over 40 years ago too. One coil, one condenser, one set of points, both plugs firing at the same time, one piston on exhaust and the other on compression. Cliff C

cbxmountainman · Post by **cbxmountainman** » Wed Jul 23, 2008 2:56 pm

Not totally positive, but I think that the 12 volt Hondas all used 3 ohm coils so just about any dual outlet 12 volt Honda coil would work. I know the CBXs are all 3 ohms. Probably a trick set up would be an Excell coil form Parts Unlimited would make a great substitution for firepower.

Swampmanfl · Post by **Swampmanfl** » Thu Jul 24, 2008 7:18 pm

CBX, would type I points be interchangeable with Type II?

Thanks again.

Honda305.com Forum

honda305.com Forum

Ordering parts for a Type 2 engine

TypeII Points

Postings

TypeII