Semitubular rivets on footpegs

Tim Allman · Post by **Tim Allman** » Thu Jun 23, 2016 4:44 pm

For some reason the general export CB77/72 has footpegs which are not hinged but the USA model pegs fold back. The rivet used in the pegs is a semitubular rivet although I don't know its size. I would like to disassemble my footpegs, replate them and reassemble but finding suitable rivets and a tool to set them seems to be a bit a bit of a problem, especially given that they will be a metric size (which of course I will know after removing the rivets).

Does anyone have any experience doing this or know of a supplier? Or, is this something that a machine shop could deal with? Or, should I be looking elsewhere?

Any help will be greatly appreciated.

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Jun 24, 2016 7:17 am

If you plate with zinc or cad they don't need to be taken apart. ...................lm

Tim Allman wrote:For some reason the general export CB77/72 has footpegs which are not hinged but the USA model pegs fold back. The rivet used in the pegs is a semitubular rivet although I don't know its size. I would like to disassemble my footpegs, replate them and reassemble but finding suitable rivets and a tool to set them seems to be a bit a bit of a problem, especially given that they will be a metric size (which of course I will know after removing the rivets).

Does anyone have any experience doing this or know of a supplier? Or, is this something that a machine shop could deal with? Or, should I be looking elsewhere?

Any help will be greatly appreciated.

Tim Allman · Post by **Tim Allman** » Fri Jun 24, 2016 2:08 pm

Ok, I'll give it a try.

Thanks.

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Jun 24, 2016 2:22 pm

It works. .....................lm

Tim Allman wrote:Ok, I'll give it a try.

Thanks.

Honda305.com Forum

honda305.com Forum

Semitubular rivets on footpegs

Semitubular rivets on footpegs

Re: Semitubular rivets on footpegs