Wrench for 10mm head bolt below spark plug?

Jlovvorn · Post by **Jlovvorn** » Tue Dec 04, 2012 11:05 pm

Can't get it good and tight with flat wrench and can't get the socket wrench in there.

Anyone have a favorite tool for this?

Goodysnap · Post by **Goodysnap** » Wed Dec 05, 2012 7:17 am

I used a 1/4 drive rachet with a shallow socket. The finer tooth and smaller the ratchet the better. Wrench doesnt work so well cause of the recess in the head.

mike in idaho · Post by **mike in idaho** » Wed Dec 05, 2012 8:46 am

5- 6 footpounds of torque, easy enough to pull with a short wrench.

Jlovvorn · Post by **Jlovvorn** » Wed Dec 05, 2012 11:16 pm

Will going at it harder do any harm, or do anything to help my oil leak?

Goodysnap · Post by **Goodysnap** » Wed Dec 05, 2012 11:44 pm

No real advantage in getting carried away with tightening that small nut. Most of the clamp load is in the 8 head studs. However a recheck after retorquing is a good idea.

Jlovvorn · Post by **Jlovvorn** » Thu Dec 06, 2012 12:01 am

Thx. Still getting a drop of oil on each run of the engine, so looking at all angles

linmictil2 · Post by **linmictil2** » Thu Dec 06, 2012 7:43 am

where is the leak coming from? Bottom of the cylinder?

honda305.com Forum

honda305.com Forum

Wrench for 10mm head bolt below spark plug?

Wrench for 10mm head bolt below spark plug?

oil leak