Pillions for 1968 CB77

Texas_E_CB77 · Post by **Texas_E_CB77** » Wed Feb 16, 2011 11:40 pm

Hey, all.

I bought a CB77 and need to replace the pillion steps on each side. I can only find the left pillion step on the internet. Question: are the right and left pillion steps interchangeable parts?

The Honda CB77 parts manual lists the two pillion steps under different part numbers (the right is: 50710-268-010 and the left is: 50720-268-000).

Any help you can provide would be great. Thanks!

Texas_E

cyclon36 · Post by **cyclon36** » Thu Feb 17, 2011 8:16 am

the main foot pegs are not interchangeable. The passenger ones should be though.

cyclon36 · Post by **cyclon36** » Thu Feb 17, 2011 9:40 pm

This set just showed up on ebay: http://cgi.ebay.com/ebaymotors/HONDA-CB ... 577wt_1165

Looks like a good deal for a fresh set that's been plated. The right side is bent slightly though. Might be an easy fix.

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Feb 18, 2011 9:00 am

The key is the different part numbers.
The CB and CL have a Right Side and a Left Side peg. ................lm

cyclon36 wrote:the main foot pegs are not interchangeable. The passenger ones should be though.

e3steve · Post by **e3steve** » Fri Feb 18, 2011 3:23 pm

To expand upon Ed's answer: the positioning of the radial dogs that surround the bolt hole differ by a few degrees. Therefore, if you were to fit two of the same on either side of the bike then they'd be at differing heights when viewed from astern; it makes the bike look lopsided.

OEM pegs are usually stamped 'L' & 'R' on the edge of the bolt flange. There are plenty out there, many on eBay, and I have a four spare (one left and three rights, I think); there are also many AM pegs kicking about.

Honda305.com Forum

honda305.com Forum

Pillions for 1968 CB77

Pillions for 1968 CB77