Clutch, Transmission, Drive Chain, Sprockets
-
nrpolo
- honda305.com Member
- Posts: 17
- Joined: Thu May 03, 2012 9:00 pm
- Location: Belen, NM
Post
by nrpolo » Fri Jul 26, 2013 9:01 pm
Put my cl77 engine together and can't find or understand the purpose of the o-ring that the clutch rod goes through. Does not seem to be in my gasket kit. What keeps it in place and where can I find one. Is there a substitute and what will happen if I omit it. Thanks
-
48lesco
- honda305.com Member
- Posts: 721
- Joined: Tue Mar 06, 2007 1:45 pm
- Location: Olmsted Twp, Ohio
Post
by 48lesco » Sat Jul 27, 2013 6:44 pm
It keeps oil from seeping through the main shaft into your clutch actuator on the right side. It goes in a groove in the main shaft. It's available from Honda.
-48
-
nrpolo
- honda305.com Member
- Posts: 17
- Joined: Thu May 03, 2012 9:00 pm
- Location: Belen, NM
Post
by nrpolo » Mon Jul 29, 2013 8:27 am
Thank you Sir. I will drive to town to get one.
-
nrpolo
- honda305.com Member
- Posts: 17
- Joined: Thu May 03, 2012 9:00 pm
- Location: Belen, NM
Post
by nrpolo » Mon Jul 29, 2013 8:28 am
Thank you Sir. I will drive to town to get one.
-
48lesco
- honda305.com Member
- Posts: 721
- Joined: Tue Mar 06, 2007 1:45 pm
- Location: Olmsted Twp, Ohio
Post
by 48lesco » Mon Jul 29, 2013 8:21 pm
If that o-ring is all you need, I have an extra one I can just mail you. Your dealer will probably have to order it anyway. PM me your address if you want it.
-48
