CL77 Pressure Plate Movement

uadmlj1 · Post by **uadmlj1** » Sat Nov 12, 2011 6:08 pm

I've got the left crankcase cover off. I just replaced the clutch cable and am trying to get it adjusted. About how much travel should I see in the pressure plate with the clutch fully dis-engaged?

uadmlj1 · Post by **uadmlj1** » Sun Nov 13, 2011 10:37 am

davomoto · Post by **davomoto** » Mon Nov 14, 2011 10:00 am

I've never had the clutch cover off and checked how much the pressure plate moves when you fully disengage the clutch. I'm sure if you have your clutch cable adjusted properly, correct lifter rod and bearing installed, you will be fine. How much movement are you seeing?

Davo

uadmlj1 · Post by **uadmlj1** » Mon Nov 14, 2011 10:11 am

Davo,

When I pull in the clutch lever to full stop, the plate moves out more than an eighth and less than a quarter of an inch. I was just wondering if this was enough to properly dis-engage the clutch.

davomoto · Post by **davomoto** » Mon Nov 14, 2011 10:43 am

Sounds like pleny of movement!

Davo

uadmlj1 · Post by **uadmlj1** » Mon Nov 14, 2011 10:47 am

Thanks Davo.

Honda305.com Forum

honda305.com Forum

CL77 Pressure Plate Movement

CL77 Pressure Plate Movement

Bump

Pressure Plate Movement

Sounds Good