Home Auctions Gallery Forum

honda305.com Forum

Vintage Honda Owners, Restorers, Riders and Admirers

'67 CL77 Fuel Screw

Fuel System: Gas (Petrol) tanks, Carburators
Post Reply
Mrburnn
honda305.com Member
Posts: 42
Joined: Tue Aug 15, 2017 2:57 pm
Location: Carlisle, PA

'67 CL77 Fuel Screw

Post by Mrburnn » Tue Jan 08, 2019 8:47 am

Good morning Forum,

Is it possible for a fuel screw to be worn to the point where if it was tightened all the way in the motor would still run? My left side screw seems to work properly in that the engine will die when it is tightened. When I tighten the right screw the motor continues to run. Any thoughts?
Top
rrietman
honda305.com Member
Posts: 561
Joined: Mon Oct 13, 2008 6:45 pm
Location: bellingham wa.

Post by rrietman » Tue Jan 08, 2019 11:38 am

plugged idle jet
Good luck
Randy
Top
Mrburnn
honda305.com Member
Posts: 42
Joined: Tue Aug 15, 2017 2:57 pm
Location: Carlisle, PA

Post by Mrburnn » Wed Jan 09, 2019 8:56 pm

Thanks Randy, I plan to pull the jet this weekend and check it out. I did pull the mixture screw for that carb tonight and found gas dripping from the tip. Is this a further indication of a plugged idle jet?

Thanks again for your time and comments!
MrBurnn
Top
Post Reply

Return to “Carburation - Fuel”