Home Auctions Gallery Forum

honda305.com Forum

Vintage Honda Owners, Restorers, Riders and Admirers

petcock screws

Fuel System: Gas (Petrol) tanks, Carburators
Post Reply
Jawja
honda305.com Member
Posts: 12
Joined: Sun Jun 13, 2004 11:43 am

petcock screws

Post by Jawja » Tue Jun 03, 2008 1:11 pm

I need two screws to hold the petcock to the tank(I have one) any ideas where I could find them?
Are there any good substitutes at home depot?? Thanks.....................
Top
joeweir1
honda305.com Member
Posts: 761
Joined: Wed Mar 08, 2006 9:35 am
Location: middletown,pa

Post by joeweir1 » Wed Jun 04, 2008 2:37 pm

What bike?CA77?I got some( 5mm )at Honda Dealer.There is another thread on this where I posted a photo of the tap I used to clean the threads al;so.
Top
Jawja
honda305.com Member
Posts: 12
Joined: Sun Jun 13, 2004 11:43 am

Post by Jawja » Wed Jun 04, 2008 7:50 pm

Yea, CA77, did you just use a regular 5mm tap? I got the 5mm screws at home depot but they didn't have a tap.
Top
3BeanCrispy
honda305.com Member
Posts: 166
Joined: Wed Mar 19, 2008 7:26 am
Location: Punxsutawney, PA

Post by 3BeanCrispy » Thu Jun 05, 2008 1:24 am

make sure to match them up against your other screw to make sure they are the correct pitch.
any hardware store (ace, true value, etc) should have single taps. both old and new pitch are commonly stocked taps. if there's nothing close try www.use-enco.com.
Top
gramey7
honda305.com Member
Posts: 116
Joined: Sun Jan 02, 2005 11:33 am
Location: Seattle, Washington

Post by gramey7 » Sat Jun 07, 2008 10:11 am

If it's not too late, try Joseph Tubb at icemanjat@hotmail.com. I have bought JIS screws from him a couple of times; he's the one on EBay often auctioning various JIS screws.
Top
Post Reply

Return to “Carburation - Fuel”