Search found 152 matches
Old HondasHello everyone Did not see you at Donnington G-Man, the big difference between the bikes in the picture and most of the bikes in the paddock with Mike Hailwood, Tommy Robb etc. on them is that these are / were genuine period race bikes, that said the I thought standard of some of the "replicas " was...
63 CB77Hello Eddie
I have some used cranks and stuff if you get stuck. I think its best to strip any used cranks you get these days, even when they "feel" good they can be in a pretty poor state. No point in spending on pistons etc. then have the bottom end give trouble. Gordon
63 CB77Hello Eddiebpool
Looks like you have a proper project on your hands there, where about in Scotland are you based. Gordon
CB 250/350 tensioner rollerHello Phill Had just noticed your post, so I measured a new K roller I had. ID 15.5mm OD on rib 55mm OD on flat 50.6mm W at bush 15mm W at outside 10mm Unfortunately it is also narrowed like a CB72/77 one ( in the wrong place for reducing it to a smaller dia. ) and the centre is too small. Pity, as ...
fuel tankHello
Stan, unless you told me I would never had realised that your tank was made from "something else". Your bike is looking good, did you ever get anywhere regarding the 350cc pistons ? Gordon
CB72 clip-onsHello Hogheaven There are a few places supplying clip-ons in the UK but check the fork diameter as early and late forks are different, where are you located ? The best known supplier for "meggas" would Swarbrick racing, (www,swarbrick-racing.co.uk) They even supply copies of both the race kit and CR...
Fork pistonsHello Gordon
I don't have any new ones but might have something better than what you have, I have sent a PM re. the sliders with my phone numbers. Gordon
|