Honda305.com Forum

I started my honda dream up. I ended up using a mikuni vm22 carburetor to replace the stock carburetor. It fits good after a few mods and i also drilled out the main jet from .036" to .045" to get it running right. Ill order the right main jet right away. I also replaced the stock rectifier with a t...

I started my honda dream up. I ended up using a mikuni vm22 carburetor to replace the stock carburetor. It fits good after a few mods and i also drilled out the main jet from .036" to .045" to get it running right. Ill order the right main jet right away. I also replaced the stock rectifier with a t...

Thanks Loud Mouse I guess I never gave the center stand much thought. I did paint the side stand black but I was not able to get the center stand off of the bike so I left it alone.

I have been very slowly puting the frame back together. I will put the engine back in as soon as the new piston rings show up. This is what i have done so far. I also need to wire everything from scratch. The old wiring harness had some bad twist and tape work on it so i decided ill make a new one o...

The number stamped on the engine is C77E-10000xx what does that tell us? Also the body of my carburetor is so warped that the float bowl doesent fit back on is there anything we can do to fix that? The carburetor has C77 B stamped on it. If this carburetor is beond repair s there a new carburetor th...

I spent yesterday working on the frame. Installed the front forks and the rear swing arm. Then I started working on the engine. I did a compression test and the results were disappointing. One cylinder has 115psi and the other had 75psi. I decided to take the top end apart and figure out what is nee...

I took the frame to a Ublast it yourself facility today. Those machines have some major power. I finished the whole job in about 15 min when I got home i finished the painting. Tomorrow ill start putting the bike back together.