Search found 62 matches
- Fri Mar 27, 2015 3:44 pm
- Forum: Wanted - Parts | Bikes | Services
- Topic: ca77 parts required, and some available
- Replies: 4
- Views: 2367
- Sun Mar 22, 2015 5:54 pm
- Forum: Everything Else
- Topic: are the chrome tank covers the same on a cb as a ca
- Replies: 1
- Views: 1385
are the chrome tank covers the same on a cb as a ca
are the chrome tank covers the same on a cb as a ca
thanks
thanks
- Sun Mar 22, 2015 3:07 pm
- Forum: Wanted - Parts | Bikes | Services
- Topic: ca77 parts required, and some available
- Replies: 4
- Views: 2367
ca77 parts required, and some available
hi ca77 #c781004397. i think its 1964, or so it says on ownership looking for chain guard upper and lower rear left winker lens both side chrome tank covers and knee pads. if you have any available i'm in ontario canada L1K 2W4 for shipping/ let me know how much$$ i also have extra parts available, ...
- Sun Oct 19, 2014 6:10 pm
- Forum: Ignition - Mechanical | Electronic
- Topic: fire only when wire is loose
- Replies: 3
- Views: 3454
fire only when wire is loose
followed ed's tune-up guide and everything was humming along nice. or so i thought would run the bike for a few minutes and vary the throttle, let cool down and check for leaks an hour later would do again and re check timing. about 4th time wasnt getting any light from strobe on left side when i wa...
- Wed Oct 08, 2014 3:42 pm
- Forum: Motors - 247cc | 305cc | 337cc | 350cc
- Topic: low compression, oil leak, and i'm an idiot
- Replies: 6
- Views: 3997
update: thanks LM your simple instructions did the trick as far as cam setup put my replacement engine stud in and its too long. tried just using a regular nut but i have some seepage so i'm going to cut of a bit and put the proper acorn on her. still have a little leak coming from tack drive area a...
- Tue Oct 07, 2014 8:00 am
- Forum: Your Suggestions
- Topic: could really use " go to page#" option
- Replies: 0
- Views: 3116
could really use " go to page#" option
reading through all posts of engine board
118 pages
got to page 40 yesterday.
decided to pick back up where i left off and only way to get back to page 40 is by hitting next 40 times.
not very intuitive.
118 pages
got to page 40 yesterday.
decided to pick back up where i left off and only way to get back to page 40 is by hitting next 40 times.
not very intuitive.
- Wed Sep 24, 2014 8:19 pm
- Forum: Motors - 247cc | 305cc | 337cc | 350cc
- Topic: low compression, oil leak, and i'm an idiot
- Replies: 6
- Views: 3997
It shouldn't take too long to pop the engine out. You can then review the cam timing , ensuring the points cam, flywheel and cam gear timing marks are correctly aligned while you are at it just to be sure should be at T on stator behind the points the line is straight up the O on the cam chain gear...