Honda305.com Forum

I meant mainly the jets, but it probably wouldn't be a bad idea to replace the needles also.

I am trying to locate needle jets for a CL77 and not having much luck. Any ideas where to look?

Slides are in correctly.
I could not find the FAQs on carb adjustment, but I am an experienced bike mechanic and adjusted them in a generic manner, same way I would adjust a pair of VM Mikunis or Amals.

I static timed to the F mark and used a strobe to make sure it hit full advance marks. I checked both cylinders. The bike runs fine and holds idle until the plugs start fouling after a few miles. I do have a very slight problem with the RPMs not dropping back as fast as they should. I did install ne...

I just rebuilt the engine on a CL72 w cl77 top end that had been sitting over 30 years. I am fuel fouling plugs in both cylinders at about 5 to 10 miles. I have the needle on the next to leanest position, new float needles and seats and D8HA plugs Stock pipes with hollow stock muffler. Float level i...

Does the CL77 have any crankcase breathing outlets besides the one at the top of the engine?
It seems kind of small. Are there any mods to help with better breathing?

Dave,
The assembly lube worked good. Much less friction then with thread lube.