Honda305.com Forum

i just posted this over in the dream section. got my carb back from loud mouse. looks brand new inside and out. very impressed. I also got a chance to speak with the man- what a cool guy! if your struggling with your carb, and he's willing to take it on, it's a very easy choice.

I just wanted to tell everyone about the wonderful job loud mouse did on my carb. I couldn't believe it was the same carb I sent him. It looked brand new inside and out and works perfectly. the cost including shipping and new parts was about $75. i recommend that if he's willing to take it on (send ...

good news, bad news. the good news- I think I fixed it! the bad- i could have spared us most of this if I had payed closer attention in the first place. there were two plates, one metal and one fiber, that were bonded so completely to the basket cover (part that the four screws and the four springs ...

yes, with the clutch plates removed, the rear wheel turns while in gear. also the ball bearing is present. How long should the push rod be? i guess i'm trying to figure it out, with as much certainty as possible, then replace the problem. I wish my resources were such that I could just start replaci...

i have the bill silvers books. should the ball bearing come out of the threaded metal piece?

took the cover off. kickstarter comes off with cover, but then everyone but me knew that ; ) . lots of old goop and gunk, but everything seems to be there, including the ball bearing. it doesn't come out of the threaded metal piece, nor does it seem to spin. is this right? What now? anything else I ...

thanks for that mike, hopefully I can get to it this week. strike while the iron is hot, and all that.