Honda305.com Forum

FYI I found a new coil from http://www.classiccycleparts.com/ I haven't put it on yet but it looks like it will work.

They're in Ohio, might be the same one Randy mentioned.

Thanks. I double checked to see where it was coming from and it is not the petcock or the crossover fitting. I will probably try some two part epoxy or JB Weld on the outside, and try drizzling some of the KREEM sealer into that corner. If that fails, I will break down and bring it to a welder, who ...

Hi, I have a 1965 Dream 305. I just bought a used tank and gas is weeping from around the mounting bolt on the right side. Anyone run into this?? The tank is clean on the inside but would a sealer help? Also is there anything anyone has used on the outside in these situations. I searched and found i...

Hello

Did a search and couln't find anything on this. I'm having a hard time finding an ignition coil

Has anyone rigged up other make/model coils for these bikes. What is the potential danger??

Randy Appreciate the response. Hope all is well. Did your bike sell??? Thanks for going back and forth with me on that whole scenario. I also see that your very helpful in this forum. I have bought a total of 4 tanks so far. One was for a Benly 160 and was wrong,(still have it) one was not much bett...

My exhaust on the 305 Dream (1965) is only warm to the touch at the end the pipe after running the bike for a while. Is this typical or should I check to make sure they are not clogged??

-------------------------------------------------------------------------------- Hi I got my 1965 305 Dream going today off a portable tank. The bike hasn't been run in at least ten years. I rebuilt the carb, put in some new plugs, set the points and got her going. A great feeling. I couldn't ride i...