CL77 in the Great Lakes

bdawson · Post by **bdawson** » Thu Sep 22, 2011 7:48 pm

This is the exhaust that came with the bike. To me it looks different than the exhausts I have seen on CL77 on line. It cleaned up nice : ) The shield/cover is a single piece.

G-man I do have other parts, just not in the photo above.

Is this the correct exhaust?

CL77 Exhaust by Brad H. Dawson, on Flickr

Brad

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Sep 22, 2011 8:42 pm

If it fits ya may want ta use it but I don't think it's correct!!!!!!!!!!. ..lm

bdawson wrote:This is the exhaust that came with the bike. To me it looks different than the exhausts I have seen on CL77 on line. It cleaned up nice : ) The shield/cover is a single piece.

G-man I do have other parts, just not in the photo above.

Is this the correct exhaust?

CL77 Exhaust by Brad H. Dawson, on Flickr

Brad

FAST FRED · Post by **FAST FRED** » Sat Sep 24, 2011 11:13 am

This muffler is for a 1971 CL450K4.

Fast Fred

bdawson · Post by **bdawson** » Sat Sep 24, 2011 9:51 pm

That was my next questions : ) Thanks Fred!

bdawson · Post by **bdawson** » Sun Sep 25, 2011 5:04 pm

I got busy and started putting some pieces back together this weekend. I am sure they will come off again, but I was having fun : ) Also, if parts are on the bike, I can't misplace them.

CL77 by Brad H. Dawson, on Flickr

bdawson · Post by **bdawson** » Sun Sep 25, 2011 5:32 pm

Wiring harness is in rough shape. Can these be 'fixed' or is it common with a restoration to replace them? Several of the connector end pieces were damaged or became damaged when I took it apart.

Front end wiring is on the right. There is a toggle switch attached to the lock due to a key broken off inside the lock.

Any suggestions to rewiring the bike would be helpful. Thanks in advance.

CL77 wiring harness by Brad H. Dawson, on Flickr

How about this? From Ebay? Picture below. Or here: http://cgi.ebay.com/ebaymotors/Honda-CL ... 230cb72881

new CL77 wiring harness by Brad H. Dawson, on Flickr

davomoto · Post by **davomoto** » Sun Sep 25, 2011 7:20 pm

vintageconnectios.com , sells a crimp on wire end kit, and grey plastic loom to rebuild your old harness. I don't recomend that replacement one!

Davo

honda305.com Forum

honda305.com Forum

CL77 in the Great Lakes

CL450 muffler