honda305.com Forum

Vintage Honda Owners, Restorers, Riders and Admirers

Latest Registry Entry
1965 Honda CP77 — Ulsan Metro City, Rep. Korea
Restored with original parts — Owner: J. Doe

Search found 62 matches

by jimpapa
Fri Mar 27, 2015 3:44 pm
Forum: Wanted - Parts | Bikes | Services
Topic: ca77 parts required, and some available
Replies: 4
Views: 2613

Speedo gone and thanks for side covers Louis
by jimpapa
Sun Mar 22, 2015 5:54 pm
Forum: Everything Else
Topic: are the chrome tank covers the same on a cb as a ca
Replies: 1
Views: 1509

are the chrome tank covers the same on a cb as a ca

are the chrome tank covers the same on a cb as a ca
thanks
by jimpapa
Sun Mar 22, 2015 3:07 pm
Forum: Wanted - Parts | Bikes | Services
Topic: ca77 parts required, and some available
Replies: 4
Views: 2613

ca77 parts required, and some available

hi ca77 #c781004397. i think its 1964, or so it says on ownership
looking for
chain guard upper and lower
rear left winker lens
both side chrome tank covers and knee pads. if you have any available i'm in ontario canada L1K 2W4 for shipping/ let me know how much$$


i also have extra parts ...
by jimpapa
Sun Oct 19, 2014 6:10 pm
Forum: Ignition - Mechanical | Electronic
Topic: fire only when wire is loose
Replies: 3
Views: 3730

fire only when wire is loose

followed ed's tune-up guide and everything was humming along nice.
or so i thought
would run the bike for a few minutes and vary the throttle, let cool down and check for leaks
an hour later would do again and re check timing.

about 4th time wasnt getting any light from strobe on left side
when i ...
by jimpapa
Wed Oct 08, 2014 3:42 pm
Forum: Motors - 247cc | 305cc | 337cc | 350cc
Topic: low compression, oil leak, and i'm an idiot
Replies: 6
Views: 4299

update:
thanks LM your simple instructions did the trick as far as cam setup
put my replacement engine stud in and its too long. tried just using a regular nut but i have some seepage so i'm going to cut of a bit and put the proper acorn on her.
still have a little leak coming from tack drive area ...
by jimpapa
Tue Oct 07, 2014 8:00 am
Forum: Your Suggestions
Topic: could really use " go to page#" option
Replies: 0
Views: 3261

could really use " go to page#" option

reading through all posts of engine board
118 pages
got to page 40 yesterday.
decided to pick back up where i left off and only way to get back to page 40 is by hitting next 40 times.
not very intuitive.
by jimpapa
Wed Sep 24, 2014 8:19 pm
Forum: Motors - 247cc | 305cc | 337cc | 350cc
Topic: low compression, oil leak, and i'm an idiot
Replies: 6
Views: 4299

It shouldn't take too long to pop the engine out. You can then review the cam timing , ensuring the points cam, flywheel and cam gear timing marks are correctly aligned while you are at it

just to be sure
should be at T on stator
behind the points the line is straight up
the O on the cam chain ...